Pyle PLXR2B, User Manual

www.PyleUSA.com

6

INSTALLATIONS

CAUTIONS:

Please follow all the installation recommendations and instructions

in this manual, Installing and for using the electronic crossover in methods other 
than those outlined herein may reduce the performance capability of the crossover. 
Any such installation or usage may render the product warranty void.

A. LOCATION

     1. Select a mounting location that is easily and conveniently accessible, e.g.
         inside the trunk.
     2. To avoid damage to the crossover, keep the crossover away from any heat
         source (such as the engine or any heat- generating ducts).
     3. There should be adequate clearance above the crossover to allow easy
         adjustment.

B. WIRING LAYOUT

     Once the location of all the components has been determined, plan the best
     routes for all the necessary wiring, making sure that the wires are easily 
     accessible without dismounting the various components.

CAUTIONS:

Routing audio cables and power cables together would invariably

cause radiated engine noise in your audio system. If possible, run audio cables on 
one side of your car and power cables on the other. Never route these wires 
underneath the vehicle body.

1. Check and make sure the vehicle s main battery and/or auxiliary battery, if any,  
     is/are in good working condition and has sufficient capacity to run the electrical  
     components of the vehicle plus the complete audio system.
2. The crossover is designed for use in 12 volt 

NEGATIVE GROUND

 electrical    

     system 

ONLY

. Installing the crossover in a vehicle with positive ground electrical  

     system could result in serious damage to the electronic crossover, other audio  
     components and/or the vehicle s electrical components.
3. 

FOR SAFETY, DISCONNECT THE BATTERY GROUND BEFORE INSTALLATION.