background image

CAUTION:

WARNING:

To reduce the risk of fire or electrical shock, do not expose this appliance to
rain or moisture.

DETAILED SAFETY INSTRUCTIONS:

All the safety and operation instructions shouldbe read before the appliance is operated.

SAFETY INSTRUCTIONS

Retain Instructions:

The safety and operating instructions should be retained for futurereference.

Heed Warnings:

All warnings on the appliance and in the operating instructions should be adhered to.

Follow instructions:

All operation and user instructions should be followed.

Water and Moisture:

The appliance should not be used near water ( e.g. near a bathtub,washbowl,kitchen sink,
laundry tub,in a wet basement,or near a swimming pool etc. )

Heat:

The appliance should be situated away from heat sources such as radiators, heat registers,
stoves, or other appliance ( including amplifiers ) that produce heat.

Power source:

The appliance should be connected to a power supply only of the type described in the
operating instructions or as maked on the appliance.

Grounding or Polarization:

Precautions should be taken so that the grounding or polarization means of an appliance is
not defeated.

Power-Cord Protection:

Power supply cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them, paying particular attention to cords and plugs,
convenience receptacles and the point where they exit from the appliance.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol, wherever it appears, alerts you to important operating and
maintenance instructions in the accompanying literature. Read the manual.

This symbol, wherever it appear, alerts you to the presence of uninsulated
dangerous voltage inside the enclosure - voltage that

be sufficient to

may

constitute a risk of shock.

The appliance should be situated so that its location or position does not interfere with its
proper ventilaton. For example,the appliance should not be situated on a bed,sofe rug,or
similar surface that may block the ventilation openings:or placed in a built - in installation,
such as bookcase or cabinet that may impede the flow of air through the ventilation
openings.

Cleaning:

The appliance should be cleaned only as recommended by the manufacturer.

To reduce the risk of electrical shock, do not remove the cover ( or back ) .No
user serviceableparts inside; refer servicing to qualified personnel.

Ventilation:

Summary of Contents for PPCX2







Reviews: