Pyle PRJTPFL102, User Manual

www.PyleUSA.com

3

INSTALLATION PROCEDURE

1. Open the carton and find the square hole at both end of the polyfoam.    

     Take out the corner connector, hanging kit, Alan head screws, wrench,  

     and springs.

2. Lay the longer frame and shorter frame on a neat and soft ground. Place  

    the L-shape corner connector in the groove of both frames and join the  

    two frames together by the corner connector. Make sure the direction of  

    frame and connectors is correct. Drive the screws into the hole of  

    connectors and make sure the frames are joined in a right angle and    

    good tightness.

3. Stretch the screen and put the fiber glass tube respectively according to    

    the length. Stretch the screen after the tubes are placed correctly. Put the  

    screen in vertical direction and make sure the screen is centered in the  

    frame. Use the spring hook to connect the hole on the frame and the    

    hole on the screen. Remember to work the springs hook on the four    

    corner of the frame first before you work on hooks elsewhere. (smaller  

    hook of the spring for the frame and the bigger hook for screen.)