3
Before you begin the installation:
•
This product must be installed by qualified
personnel according to these instructions.
• Verify with the customer the desired
location for the program switch and LED.
• Always use a multimeter when verifying
vehicle wiring.
Installation Notes:
• Do not install the main unit in the engine
compartment.
• Make all wiring connections to the vehicle
before connecting the main 15-pin
connector harness to the main unit.
• Mount the main unit in a secure area, away
from vehicle computers and heating/air
conditioning ducts. Mount the unit as far
away from metal objects as possible to
increase the range of the remote
transmitters.
• When running the harness wires through
the vehicle, be careful to run them where
they cannot be damaged or shorted. Keep
them away from any moving parts or areas of
high heat. Use rubber or plastic grommets to
protect the harness wires where they pass
through holes in metal panels.
Main Harness:
• BLACK WIRE - Ground input (-). Connect to
a
solid chassis ground that is clean and free
of paint or dirt.
• RED WIRE - +12V battery input.
• WHITE WIRE - Parking light output (+).
Connect to the wire that shows +12V when
the parking lights are on. If the vehicle’s
parking light circuit exceeds 10A, a relay is
required. For vehicle’s with independent left
and right parking light circuits, the parking
light wires must be connected using diodes
to keep the circuits separate.
• WIRE - Unlock #87 normally open input
10A fuse.
(see Door Lock Wiring Diagrams)
• BLUE/BLACK WIRE - Unlock #30
common output.
(see Door Lock Wiring
Diagrams)
• BROWN/BLACK WIRE - Unlock #87A
normally closed input.
(see Door Lock Wiring
Diagrams)
• VIOLET/BLACK WIRE - Lock #87
normally open input 10A fuse.
(see Door Lock
Wiring Diagrams)
• GREEN/BLACK WIRE - Lock #30
common output.
(see Door Lock Wiring
Diagrams)
• WHITE/BLACK WIRE - Lock #87A
normally closed input.
(see Door Lock Wiring
Diagrams)
• ORANGE WIRE - Armed Output (-)
500Ma. The ORANGE wire provides ground
when the unit is armed to activate a starter
disable relay. Connect to a relay for starter
defeat..
(See Relay Wiring Diagrams)
• BLACK/YELLOW - Dome light output (-)
500mA. Connect to a relay to activate the
dome light when the system is unlocked.
(See
Relay Wiring Diagrams)
• GRAY WIRE - Auxiliary output (-) 500mA.
Connect to a relay for optional trunk release
etc.
(See Relay Wiring Diagrams)
• BROWN WIRE - Horn honk output (-)
500mA. Connect to a relay to honk the
vehicle’s horn.
(See Relay Wiring Diagrams)
INSTALLATION INSTRUCTIONS
853 new.qxd 3/15/2004 12:44 PM Page 3
