5
provides a ground when the unit is armed to
activate a starter disable relay or other device
(i.e. window control module, etc.).
• BROWN/WHITE WIRE - Horn output (-)
500mA. Connect to an optional relay to activate
the vehicle’s horn when the alarm is triggered.
• BLACK/WHITE WIRE - Dome Light output
(-) 500mA. Connect to an optional relay to
activate the vehicle’s dome light.
• BLUE WIRE - Trunk/Hood trigger (-).
Connect the Blue wire to the trunk and/or
optional hood pin switches. The switch must
provide a ground output when switch is opened.
• GRAY WIRE - Auxiliary output (-) 500mA.
Connect to a relay for an optional feature such
as trunk release, etc.
• YELLOW WIRE - +12V Ignition input.
Connect to a main ignition wire at the ignition
switch harness.This wire shows +12V when the
ignition is on and while cranking. The voltage
must not drop when the car is starting.
• BLACK WIRE - Ground input (-). Connect to
a solid chassis ground that is clean and free of
paint or dirt.
• VIOLET WIRE - Positive door trigger (+).
Connect to the door switch circuit wire that
shows +12V when the door is open. This type
of door circuit is usually found on Ford vehicles.
• GREEN WIRE - Negative door trigger (-).
Connect to the door switch circuit wire that
shows ground when the door is open.
Plug in Connectors
3-Pin White Door Lock Connector:
Plug-in
connector port for door lock harness or
optional door lock relay module.
• BLUE WIRE - unlock output (-) 500mA.
• RED WIRE - +12V output (+) 300mA for relay
modules, or inverters. Do NOT use as a power
source for door lock relays.
• GREEN WIRE - lock output (-) 500mA.
2-Pin Red Connector:
Plug-in connector
port for LED. Mount LED in an area where it
may be easily seen from either side of the
vehicle.
2-Pin Blue Connector:
Plug-in connector
port for valet switch. Mount switch in an area
that is easily accessible from the driver’s seat.
4-Pin White Connector:
Plug-in connector
port for dual stage shock sensor.
Entering Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5
times.
• The siren will emit a long chirp, to
indicate entering program mode.
3. Press the valet switch the number times
equal to the desired feature.
• The siren will chirp each time the valet
switch is pressed.
4. Within 5 seconds, press the transmitter
button corresponding to the desired
operating mode for that feature.
• The siren will chirp to indicate the
setting.
One chirp = Button 1 (default setting)
Two chirps = Button 2
Three chirps = Buttons 1&2
5. Turn off ignition to save changes.
