2
IGNITION CONTROLLED LOCKS
The ignition controlled locks feature
automatically locks the doors when the brake
pedal is pressed (after turning on the ignition
and closing all doors), and unlocks when the
ignition key is turned off. This feature may also
be programmed for ignition lock without
ignition unlock, and off (no ignition control).
VALET MODE
When the system is placed into the Valet Mode
the remote start feature will be disabled.
However, the optional keyless entry and trunk
release features will still function if installed.The
valet mode may be accessed with either the
valet switch or a remote transmitter.
To enter or exit valet mode using the switch:
1. Be sure the system is in unlock mode.
2. Turn ignition on.
3. Press and hold the valet switch for 3
seconds.
• The LED will turn on solid indicating
the system is in valet mode, or turn off
indicating valet mode exit.
• The parking lights will flash 4 times to
enter and 3 times to exit valet.
• The LED will turn on solid indicating
the system is in Valet Mode, or turn off
indicating Valet Mode exit.
4. Turn ignition off.
To enter or exit valet mode using the remote:
1. Press and hold button 1 for level shift.
2. Press button 1 again to turn valet mode.
• The optional 2-way LCD transmitter
display will show “zzz” for valet .
OPTIONAL TRUNK RELEASE
The activate the system’s auxiliary feature (or
trunk release) press button 3 for level shift,
then press button 3 again.The parking lights will
flash 3 times.
CAR LOCATOR FEATURE
The activate the system’s car locator feature
press button 3 twice rapidly. The parking lights
will flash 6 times.
REMOTE START FEATURES
Important: Only start the vehicle in a well
ventilated area. Do not use in a closed garage
or indoors. Be sure to familiarize yourself with
all features prior to using the remote start.
REMOTE STARTING THE VEHICLE
To remote start the vehicle:
1. Press and hold button 2 for level shift.
2. Press button 2 again.
• The parking lights will begin flashing (or
remain on depending on programming).
• The system will attempt to start the
vehicle.
• Once the car has started, the heater or
air conditioner will turn on and run for
the pre-programmed time. If the engine
fails to start on the first attempt, it will
attempt to start 3 more times. If the
vehicle fails to start after a total of 4
times the system will shut down.
To drive the vehicle after Remote Starting:
Unlock the door by pressing button 2 on the
remote transmitter. Enter vehicle, turn
ignition key to the on position
NOTE: Do not turn the key to the start position
as the engine is already running.
If brake pedal is pressed prior to turning on
ignition, engine will turn off.
REMOTE ENGINE SHUTDOWN
If the vehicle has been remotely started and
you desire to turn the vehicle off, simply press
and hold button 2 for level shift, then press
button 2 again.
S series.qxd 9/24/2004 11:08 AM Page 2
