15
2.1.3.
Cable Shield Grounding
Camera and frame grabber cable “outer” shields are connected to the CLT-351R/L
aluminum case. Case and endplate contacting surfaces are unpainted, providing a
Faraday cage to shield internal circuitry. The case is isolated from the CLT-351R/L
circuitry and the cable “inner” shields, avoiding possible safety concerns.
The frame grabber cable “inner” shield connects to circuit digital ground, maintaining
signal reference levels between the CLT-351R/L and the frame grabber.
The Camera Link
TM
Specification recommends that a provision be incorporated into
frame grabbers that enable the inner shields be tied to digital ground either directly, or
through a parallel R/C network. In the CLT-351R/L, the
camera connector
represents
the Camera Link
TM
frame grabber interface. To incorporate this flexibility, the CLT-
351R/L ties the inner shields from the camera connector to digital ground through 0-
ohm resistors. If necessary, the 0-ohm resistors may be replaced with a parallel RC
network.
Summary of Contents for CAMERA LINKT CLT-351L
