Pyronix ATLAS 8 PLUS Installation Manual Download

Page: 14 / 69

is active again.

Follow Kiss Off:
This option will allow the programmable output to switch on for a few seconds when a communication kiss off
has been successfully completed.

Shock Sensor Reset:
When the panel is reset after an alarm activation and the panel is set, power to the shock sensors will be
momentarily disconnected to reset any sensors connected to the programmable output.

System Option 1. The system may be configured for use with the following:

Double Pole Zones: This is a normally closed zone configuration without end of line resistors.

End of Line Zones: This configuration uses end of line resistors which allow both zone and

tamper circuits on the same zone connection.

User Log Reset Enable: This option allows the user to reset the system log by entering

User Log Reset Disable: By selecting this option only the engineer has the ability to reset
the system log.

Tone Dial: Select this option for telephone exchanges using tone dial technology.

Internal & External Sounders On Tamper Activation: This option will cause both internal and
External sounders to activate on a tamper alarm when the panel is in day mode.

Internal Sounder Only On Tamper Activation: This option will cause only the internal sounder
to activate upon a tamper alarm when the panel is in day mode.

System Option 2. The system may be configured for use with the following:

7 Day Test Dial: Dials the alarm receiving centre every 7 days.

24 Hour Test Dial: Dials the alarm receiving centre every 24 hours.

Dial In: This option will allow the panel to respond to an incoming call in Answer Machine
Compatible mode for uploading / downloading of programming information.

Answer Machine Compatible mode (AMC): This provides a way of using the Atlas on the
same line as an answering machine. The default setting is Answer Machine Compatible on.
To remotely access the Atlas in Answer Machine Compatible mode, dial in and wait for a
single ring, then hang up and wait for at least 10 seconds, but no more than 40, then dial back
in. The Atlas will now answer instantly.

No Dial In: This option will allow the panel to ignore incoming calls. The master / manager
user may generate a one hour time window to allow up/downloading by using this function. If
this option is selected - this will answer on a single ring or dial out if telephone number 3
exists.

Wide handshake filters: Gives a greater chance of the handshake from a central station being
recognised, use only if the panel does not transmit data after the correct handshake sequence
has been transmitted by the central station.

Standard handshake filters: This setting is the default and will more reliably detect the correct

handshake.

BSIA test dial enable / disable: the on board Digicom will dial out every 7 days or every 24
hours depending on setting 1.

Silent P.A. Zones: The P.A. zone activation will not generate internal or external sounders if
this option is selected. Dial out will occur however if the panel has been programmed to do so.

Audible P.A. Zones: The Personal Attack zone activation will cause both internal and
external sounders to operate. Dial out will also occur if the panel has been programmed

to do so.

Page 14