Disassemble the Keypad
Cable and Screw Mounting Holes
The Printed Circuit Board
2.
Insert a wide flat-head screw-driver
into each of the two lugs on the underside
of the keypad (as shown above).
3.
Lever the screwdriver as shown in
the direction above to open the cover.
1.
Loosen the screw on the
underside of the keypad.
lugs
D1-
RESET
JMP1
TAMPER
D2+
D3
D4
-
+
Z1
Z2
PGM1
D1-
= 0V
D2+
= 12v+
D3
= RS485 ‘A’ BUS
D4
= RS485 ‘B’ BUS
NOTE: If the keypad cover is not needed,
there is a bottom keypad cover supplied that
can be fitted
Cable Routes
Screw Holes
Insert a screw into the rear
tamper break out section. If
the keypad casing is pulled off
the wall, the break out section
will stay fixed, and a tamper
activation will occur.
Location:
Keypads/Tag readers should not be mounted on metal surface, or be located within
1m from each other. Loudspeakers also should not be located within 1m from a keypad/tag
reader, other tag reader response will degrade.
