background image

E

LECTRONIC 

S

ILHOUETTE 

 

 

 

 

 

Page 9

Warranty – Australia Only

 

DIY (Do It Yourself) installation Warranty 

  If the product has been installed as a DIY, a supply part only warranty will apply. Parts 

only will be supplied free of charge on the return of the faulty part and the owner will 
be  responsible  for  all  labour  charges  incurred  for  the  part  to  be  fitted  by  a  qualified 
person. Labour warranty as prescribed in the following table is void in this situation. 

Remote Location Warranty 

  If the product has been installed outside the Climate Technologies service network, a 

supply part only warranty will apply. Parts only will be supplied free of charge on the 
return  of  the  faulty  part  and  the  owner  will  be  responsible  for  all  labour  charges 
incurred for the part to be fitted by a qualified person. Labour warranty as prescribed 
in the following table is void in this situation. 

Exclusions to warranty 

  Consumable items subject to wear and tear such as filter pads, drive belts and bearings are 

not covered by this warranty. 

  Components  used  as  part  of  the  installation  such  as  grilles  filters,  ducting,  fittings,  zone 

motors and consumer services pipe work are warranted from your place of purchase and not 
covered by this warranty. 

  Damage caused by elements such as wind, rain, lighting, floods etc along with power spiking 

and  brownouts  are  not  considered  defective  material  or  workmanship  and  as  such  are  not 
considered warranty. 

  No  responsibility  will  be  accepted  for  outside  elements  such  as  pests,  animals,  pets  and 

vermin that may cause damage to the unit.  

  Harsh environmental situations such as salt air that may cause cabinet damage / rusting can 

not be considered warranty.  

  The  manufacturer  does  not  accept  liability  or  any  claims  for  damage  to  building  contents, 

carpet,  walls,  ceilings,  foundations  or  any  other  consequential  loss  either  direct  or  indirect.  
Damage  resulting  from,  power  spikes,  incorrect  operation,  incorrect  installation,  incorrect 
maintenance is also not covered. 

  All warranties are NOT transferable. 

Conditions where warranty may be void 

  If there is no certificate of compliance for plumbing, electrical or refrigeration as required by 

State  &  Territory  Laws.  Climate  Technologies  reserves  the  right  to  refuse  service  on  non-
compliant installations. 

  The  defective  operation  of  the  appliance  that  is  due  to  failure  of  electricity,  gas,  water  or 

refrigerant gas supplied. 

  Defects are caused by neglect, incorrect application, abuse or by accidental damage of the 

appliance. 

  An unauthorized person has attempted to repair the appliance. 

  A situation arises referenced in the trouble-shooting guide.  

  A charge will be made for, work done or a service call where there is nothing wrong with the 

appliance. 

Summary of Contents for 4740001














Reviews: