AUDIO OUT
L
R
Analogue
RCA / PHONO Lead
RCA /PHONO Lead
Locate the remote control and RCA / PHONO lead provided (page 4). Position both switches on the
top of Q-TV2 to normal and select the most appropriate room position setting (see page 14).
Connect the phono lead provided to the TV’s RCA /PHONO connection labelled
AUDIO OUT
.
Connect the other end to Q-TV2 connection labelled
LINE IN
. Wire Red to Red and White to White.
Connect the power supply provided to Q-TV2. The LED will illuminate when connected.
Silence your TV speakers by turning the TV volume down to zero, do not mute the TV. Use the Q-TV2
Remote to turn up the volume on Q-TV2. If you experience bad synchronisation between sound and
vision using this connection method view the section on SET DELAY (Lip Sync) (Page 14)
Select only one of the connections detailed
Important Note
Connecting to Q-TV2 via this
method requires that you use the Q-
TV2 remote to operate the volume.
Important Note
Always ensure that
TV IN
socket is
left vacant when connecting via
LINE IN. Do not insert an additional
source into
TV IN
.
No Sound ?
Ensure that you have connected to
the TV connections labelled
AUDIO
OUT
. Always use connections on
the rear of your TV.
Connections
Ü
Quick Start Guide
Page 11
16V 5A
Power
Q-TV2
16V 5A
Insert into Q-TV2
Power Cable
UK
EU
Power Supply
Select off
position
before
connection
Power Supply
Select on
position
after
connection
Important Note
Do not insert the plug into an electrical outlet
until all other connections have been made
Ü
