Digital
Optical Lead (Not Provided)
Optical Lead
Q-TV2 does not include an optical lead so you will need to purchase one if you wish to connect via
this method. Locate the Q-TV2 remote control. Position both switches on the top of Q-TV2 to normal
and select the most appropriate room position setting. Connect the optical lead from Q-TV2’s
OPTICAL IN
to the TV’s optical connection labelled
OPTICAL OUT
or
DIGITAL OUT
.
Select only one of the connections detailed
OPTICAL
OUT
AUDIO
OUT
Background Noise ?
Check That your TV’s Optical output
is set to
PCM Mode
. This unit does
not decode Dolby Digital
®
or DTS
®
bitstream outputs.
Connections
Ü
Quick Start Guide
Page 12
16V 5A
Connect the power supply provided to Q-TV2. The LED will illuminate when connected.
Silence your TV speakers by turning the TV volume down to zero, do not mute the TV. Use the Q-TV2
Remote to turn up the volume on Q-TV2. If you experience bad synchronisation between sound and
vision using this connection method view the section on SET DELAY (Lip Sync) (Page 14)
Important Note
Connecting to Q-TV2 via this
method requires that you use the Q-
TV2 remote to operate the volume.
Important Note
Always ensure that
TV IN
socket is
left vacant when connecting via
LINE IN. Do not insert an additional
source into
TV IN
.
Power
Q-TV2
16V 5A
Insert into Q-TV2
Power Cable
UK
EU
Power Supply
Select off
position
before
connection
Power Supply
Select on
position
after
connection
Important Note
Do not insert the plug into an electrical outlet
until all other connections have been made
Ü
