SCART Connection (Not Provided)
SCART to 2 x RCA PHONO Lead
(Not Provided)
If you are unable to connect your TV to Q-TV2 via any other methods on page 9 then it is possible to
use your TV’s SCART Connection. To connect via this method you will need a
SCART to 2 X RCA /
PHONO
connector or equivalent lead. These are available from your local Dealer.
Locate the remote control (page 4). Position both switches on the top of Q-TV2 to normal and select
the most appropriate room position setting (see page 14). Connect the
SCART to 2 x RCA PHONO
lead into Q-TV2 Labelled
LINE IN
. Locate the SCART Connections on the rear of your TV and insert the
SCART Lead.
Ü
Page 16
16V 5A
Select only one of the connections detailed
Alternative Connections
SCART
Connect the power supply provided to Q-TV2. The LED will illuminate when connected. Silence your
TV speakers by turning the TV volume down to zero, do not mute the TV. Use the Q-TV2 Remote to
turn up the volume on Q-TV2.
Important Note
Connecting to Q-TV2 via this
method requires that you use the Q-
TV2 remote to operate the volume.
Important Note
Always ensure that
TV IN
socket is
left vacant when connecting via
LINE IN. Do not insert an additional
source into
TV IN
.
No Sound ?
Check the SCART Connection menu
on your TV. Make sure that it is set
to output the source being viewed.
Refer to the TV manufacturers guide
if unsure.
Power
Q-TV2
16V 5A
Insert into Q-TV2
Power Cable
UK
EU
Power Supply
Select off
position
before
connection
Power Supply
Select on
position
after
connection
Ü
Important Note
Do not insert the plug into an electrical outlet
until all other connections have been made
