CAUTION: All the fingerprints enrolled will be deleted.
2.8
2.9
What is passage mode ?
8
8
The lock is in open status all the time. One can rotate the handle and
unlock the door at any time. This operation is suitable for office or
meeting room.
How to set the door into passage mode?
Step 2: Within 5 seconds after unlocking the door with either
fingerprint or unlocking code, press the digit
0
and hold it for 2
seconds, a long beep is heard and release the press. The lock has
been set into passage mode . You can open the door by rotating the
handle any time till you cancel the setting. (figure 2-22)
Press the digit
0
and
hold it for 2 seconds
8
How to cancel passage mode ?
There are two options:
A.Input the valid Wake-up Code and the lock come back to close
state. Or,
B.Input the valid unlocking code and the lock come back to close
state.
Step 1: Open the battery cover .
Step 2: Take out 1 of the batteries, then replace the battery again after
3 seconds. Press and hold the digits
0
,
1
,
2
,
3
at the
same time while replacing the battery. Release the digits after the red
and green indicator flashes and a long beep and a short beep are
heard.
CAUTION: The operation will delete all enrolled fingerprints, Please
make sure you wanna do that.
3.Installation
3.1
Door requirement
Wooden door with thickness from 30-
60mm;
If the door surface is decorated, the
distance from the decorative edge to
the door frame must be above 110mm.
Input fingerprint enrollment
code continuously (the default
fingerprint enrollment code is
2,1,3,2,1,3,2,1,3,2,1
How to initialize the lock?
Step 1: Unlock the door with unlocking code or enrolled fingerprint first
refer to 2.3.5 or 2.6;
Passage mode
H
tt
p
:/
/w
w
w
.q
-s
e
e
.c
o
m
LOCK
30~60mm
110mm
