QSD42908C8 User’s Manual
67
5.17 PTZ (Pan, Tilt, Zoom)
There is one RS-485 port on the DVR rear panel used for PTZ camera control. You can setup
RS-485 parameters to match your PTZ protocol. In main menu, move the “Active Frame” to PTZ
icon and press
【
ENTER
】
key, you will enter into PTZ menu as shown in fig 5.29
Fig 5.29 PTZ parameters setup
PTZ menu description
Select channel:
Select a PTZ camera.
RS-485 parameters:
Including baud rate, data bit, stop bit, parity, flow control, etc. These
parameters must be the same as those of PTZ. Protocol.
PTZ address:
Each PTZ has a different address.
PTZ type:
DVR supports the following PTZ protocols: YouLi, LinLin-1016, LinLin-820,
Pelco-p, DM DynaColor, HD600, JC-4116, Pelco-d WX, Pelco-D, VCOM VC-2000, NetStreamer,
SAE/YAAN, Samsung, Kalatel-312, CELOTEX, TLPelco-p, TLHHX-2000, BBV, RM110,
KC3360S, ACES, ALSON, INV3609HD, Howell, Tc Pelco P, Tc Pelco D, AUTO-M, AUTO-H,
ANTEN, CHANGLIN, DeltaDome, XYM-12, ADR8060, EVI-D30, DEMO-SPEED,
DM-PELCO-D, ST832, LC-D2104, HUNTER, A01, TECHYIN, WEIHAN, LG, D-MAX,
Panasonic, KTD-348, infinova, PIH-7625, LCU, DennarDome, etc. Other PTZ protocols may be
added with new firmware updates.
Note: In DVR “PTZ” menu, if you select Pelco-P protocol, when you setup PTZ address,
