13
All main functions are described as followed:
5.1
Copy Disc
We strongly recommend you to choose this function to make a CD-to-CD
duplication. With this function, it can backup exactly the same CD as the
source disk, with excellent accuracy.
5.2
Test Copy Disc
To simulate the copying process of CD-Backup, you may execute this [Test
Copy Disc] function. This function is almost the same as [Copy Disc].
However, data will not be actually written to an empty disk; its primary
function is to estimate the feasibility of writing data to the empty disk. In
fact, CD-Backup can duplicate any CD except those have serious scratches
on it.
5.3
Raw Copy Disc
With this function, it can duplicate exactly the same CD as the source disk,
even the protected ones, with excellent accuracy. In order to use this
function, you must use CR-852E/854E/856E CD-ROM drive. Maximum
copy speed is 4X.
The trays of CD-ROM and CD-R/RW writer should be pushed out
manually. Put the master CD into CD-ROM and the blank CD-R/RW disc into
CD-R/RW writer. Close the trays. When both devices detect the master CD and
CD-R/RW disc, the duplication will start automatically.
While the duplication, the LEDs of users selected mode keep flashing. If
users would like to stop the duplication, just power off the external case.
When duplication is completed, the LEDs of users selected mode will stop
flashing. The CD-R/RW disc will be ejected automatically. The users should
take out the CDs and put in new CD-R/RW disc. The duplication will start
again.
If duplication fails, the LEDs of users selected mode will stop flashing and
the power LED will be flashing several times continuously. The master CD or
CD-R/RW disc will be ejected automatically. The users should take out the CDs
and put in new master CD or CD-R/RW disc. The duplication will start again.
