User Manual
Q-Tech Q-P019 -
Electric Airless Spray Pump
6
•
NEVER
spray in vicinity of open flame
or other sources of ignition.
•
The spraying area must be at least 20
ft. away from spray unit.
SPRAY GUN SAFETY
•
ALWAYS
set gun safety lock in the
"LOCKED" position when not in use &
before servicing or cleaning.
•
NEVER
remove or modify any part of
the gun.
•
ALWAYS REMOVE THE SPRAY TIP
when cleaning. Flush unit at the
LOWEST POSSIBLE PRESSURE.
•
ALWAYS
check operation of all gun
safety devices before each use.
•
Be very careful when removing the
spray tip or hose from the gun. A
plugged line will contain fluid under
pressure. If the tip or line is plugged,
follow the pressure relief procedure
TIP GUARD
•
ALWAYS
have the tip guard in place
on the spray gun while spraying. The
tip guard alerts you to the injection
hazard and helps prevent accidentally
placing your fingers or any part of your
body close to the spray tip.
SPRAY TIP SAFETY
•
Use extreme caution when cleaning or
changing spray tips. If the spray tip
clogs while spraying, engage the gun
safety latch immediately. ALWAYS
follow the
PRESSURE RELIEF
PROCEDURE
and then remove the
spray tip to clean it.
•
NEVER
wipe off build up around the
spray tip.
TOXIC FLUID
HAZARD
•
ALWAYS
remove tip guard & tip to
clean
AFTER
pump is turned off and
the pressure is relieved by following
the
PRESSURE RELIEF
PROCEDURE.
•
Hazardous fluid or toxic fumes can
cause serious injury or death if
splashed in eyes or on skin, inhaled or
swallowed. Know the hazards of the
fluid you are using. Store & dispose of
hazardous fluid according to
manufacturer, local, state & national
guidelines.
•
ALWAYS
wear protective eyewear,
gloves, clothing and respirator as
recommended by fluid manufacturer.
HOSES
•
Tighten all of the fluid connections
securely before each use. High
pressure fluid can dislodge a loose
coupling or allow high pressure spray
to be emitted from the coupling and
result in an injection injury or serious
bodily injury.
•
Only use hoses with a spring guard.
The spring guard helps protect the
hose from kinks or other damage
which could result in hose rupture and
cause an injection injury. Do not allow
kinking or crushing of hoses or allow it
to vibrate against rough, sharp or hot
surfaces.
•
Use only conductive fluid hoses for
airless applications. Be sure the gun is
grounded through the hose
connections. Use only high pressure
airless hoses with static wire which are
approved for 3000 psi.