User Manual
7. ACL service configuration
81
www.qtech.ru
The "no traffic-limit" command is used to cancel restrictions on the traffic received on the specified
port. After the configuration is successful, the system will not have any speed limit on the port.
OLT (config) # no traffic-limit ingress ACL 2222 rule 1 port gpon-
olt1 / 11
7.4.3.
Traffic-Mirror
The traffic-mirror command is used to mirror messages that are filtered by the ACL rule on the
specified port. When a message that is received or sent at a port needs to be monitored, this
command can be used to mirror the message that the port needs to monitor to the designated port.
Please be noted that the destination port needs to configure the corresponding VLAN, otherwise the
traffic can not be forwarded successfully.
OLT (config) # traffic-mirror ingress ACL 2222 rule 1 port gpon-
olt1 / 11 to-port gpon-olt1 / 2
The "no traffic-mirror" command is used to cancel messages mirroring the specified port filtered by
the ACL rule. Once the configuration is successful, the system no longer mirrors the port traffic.
OLT (config) # no traffic-mirror ingress ACL 2222 rule 1 port gpon-
olt1 / 11
7.4.4.
Traffic-Priority
The "traffic-priority" command is used to configure priority tags for messages that are filtered
by
the
ACL
rule
on
the
specified
port.
Use
this
command
when
you
need
to
configure priority
tags
for
traffic
over
a
specified
port.
After
the
configuration
is
successful,
the
port
will forward
the
message
matching
the
ACL
rules
according
to
the
priority
to
realize
the
different QoS
guarantees.
Among
them,
cos,
DSCP,
ip-precedence
will
only
modify
the
message
content,
and
not
affect the
message
into
queue;
modification
of
local-precedence
will
affect
the
message
into
queue; traffic-
priority in the message in-bound configuration can modify the queuing-in
rule.
OLT (config) # traffic-priority ingress ACL 2222 rule 1 cos 1 port
gpon-olt1 / 11
OLT (config) # traffic-priority ingress ACL 2222 rule 1 cos 1
local-precedence 4 port gpon-olt1 / 11
OLT (config) # traffic-priority ingress ACL 2222 rule 1 dscp 1 port
gpon-olt1 / 11
OLT (config) # traffic-priority ingress ACL 2222 rule 1 dscp 1
local-precedence 3 port gpon-olt1 / 11
OLT (config) # traffic-priority ingress ACL 2222 rule 1 dscp 1 cos
2 port gpon-olt1 / 11
OLT (config) # traffic-priority ingress ACL 2222 rule 1 dscp 1 cos
2 local-precedence 4 port gpon-olt1 / 11
The "no traffic-priority" command is used to cancel the configuration priority tag for the message
under
the
specified
port.
Once
the
configuration
is
successful,
the
system
no
longer handles priority
for specified
messages.
Summary of Contents for QSW-9010
Page 1: ...USER MANUAL www qtech ru QSW 9010 CLI Configuration user manual QSW 9010...
Page 23: ...User Manual 2 Basic service configuration 23 www qtech ru...
Page 71: ...User Manual 6 QoS service configuration 71 www qtech ru...
Page 96: ...User Manual 12 Port statistics and PM statistics 96 www qtech ru...
