11
M
ic
C
ommander
START-UP
Turn on the MicCommander by pressing the button on the top of the unit. Upon powering up, the
MicCommander will display a list of transmitters to which it is currently registered. If the desired transmitter is
not displayed on this Active Transmitters list, it must be added.
SETTINGS
Select a transmitter from the active transmitters list
with the “ENTER” button to view or edit its settings.
When selected, the menu on the left will appear, the
menu on the right is accessed by selecting “Next”
Frequency
:
Frequency can be adjusted by moving the cursor to the frequency value using the navigational
arrows then pressing “ENTER” button. This will bring up the screen shown on the right.
To change the MHz values use the UP/DOWN arrows. To edit the frequency’s kHz, press the
“RIGHT” button to highlight them then use the “UP/DOWN” arrows again. The “ENTER” or
“BACK” button can be used to save changes. Select “Save” to confirm or “Cancel” to cancel.
Power
:
From this location the transmitter power can be set to ON or STBY.
Battery
:
Battery is the percentage of battery life remaining. The “CHG” to the left of the percentage denotes that the
device is currently charging.
Mic
:
Mic is the microphone state, either Live or Mute. Muting will turn the audio off and leave the transmitter UHF
carrier on. This function can be used to remotely mute a mic on any QT-
5100
transmitter or to override a physical
mute switch on transmitters such as the QT-
5100 CoachMic.
