Heat meter calculator QALCOMET HEAT 1
PEQMH1V01
37
- To read out all measured data and the data from calculator archive
- To read out and change the settings of regulator
- To read out and change the configuration settings of calculator (only listed in Table A1 in
section “Before installation”.
Reading of data and configuration of calculator settings can be performed via digital
communications interface and in conjunction with the configuration programme installed on PC.
8.8.4. Restriction of operating time of optical interface for battery supply version:
The optical interface starts work (is activated) only after pressing any control button and shuts
down after 5 minutes, after the last pressing any button or after completing data transmission via
interface.
8.8.5.The total working time of serial communication interface, for protection of the battery
against premature discharge (only for battery supply version), is limited.
Total time of sending and receiving data per month not more than 80 min (interface is blocked
after decline of time limit). It can be unblocked after forced activation with any control button not more
than for 5 min.
9.
RE VERIFICATION
Metrological control of heat meter calculator parameters is performed according to requirements
defined in EN 1434-5.
10.
TRANSPORTATION AND STORAGE REQUIREMENTS
Packed equipment may be transported in any type of covered vehicle. Equipment should be
anchored reliably to avoid shock and possibility to shift inside vehicle.
Equipment should be protected against mechanical damage and shock.
Equipment should be stored in dry, heated premises, where environment temperature is not lower
than +5
o
C. No aggressive chemical substances should be stored together because of corrosion hazard.
11.
WARRANTY
11.1. Manufacturer gives the warranty that equipment parameters will meet the technical
requirements, listed in the paragraph 2 of this document, if transportation, storage and operation
conditions will be followed.
11.2. Warranty period - 12 months from bringing into operation, but not more than 18 months
from manufacturing date.
Manufacturer’s address:
AB “AXIS INDUSTRIES”,
Kulautuvos g. 45a,
LT47190 Kaunas,
Lithuania
tel. (+370 37) 360234;
fax. (+370 37) 360358.
info@axis.lt
www.axis.lt
Summary of Contents for HEAT 1
