Charging Tips
To Prevent Damage to Spot/flood light and Battery:
•
Do not attempt to use spot/flood light while charging directly from AC
outlet. Doing so may cause damage to battery and AC charger.
•
12-volt DC charger/adapter operates from a cigarette lighter receptacle
for charging battery in spot/flood light only while vehicle engine is
running or continuous corded operation with or without battery.
•
Do not attempt to charge battery pack using both AC an DC chargers
at the same time.
•
Only use charging devices that are provided with the Q-Beam Max
Million™
IIII
Rechargeable Spot/Flood Light or its replacements.
•
For DC Charger/Adapter -
Battery charges only while vehicle engine
is running.
For AC Charger -
Allow battery to fully charge. L.E.D. indicator on
battery will automatically turn off when battery is fully charged.
See chart for recommended charge times.
•
Do not allow battery to completely discharge. A dim light indicates a
low battery. Recharge battery as soon as possible after each use.
•
Always keep the battery fully charged when not in use.
10
4
6
8
10
20
DC Charge
AC Charge
USAGE
(Minutes)
CHARGE TIME (Hours)
Charge Times
Charge times are dependent on usage of the
product. See chart below for recommended charge times.
6
To Replace Cigarette
Lighter Plug Fuse
Lighter Plug
Lighter Cap
Lighter Plug
Lighter Plug
Lighter Cap
Fuse
Fuse Holder
Lighter Cap
Lighter Cap
Step 1:
Disconnect spot/flood light from power source.
Step 2:
Unscrew cap of lighter plug and pull straight away from fuse.
Step 3:
Pull fuse holder and fuse out of lighter plug. Observe to see if
fuse is burned out.
NOTE:
Use a 8A fuse only. Fuse is burned out when fuse element is
missing or broken inside glass tube. Replace with new 8A fuse
if fuse element is missing or broken.
Step 4:
Pull fuse out of fuse holder. Insert new fuse into holder.
Step 5:
Insert fuse holder and fuse into lighter plug.
Step 6:
Screw cap onto lighter plug.
INSTR_800-2655-3_MM2.qxd 9/26/05 10:32 AM Page 7
