qcconveyors.com
| Introduction to Maintenance —
Safety Precautions
| 21
Before Maintenance
1) Maintenance functions can only be performed after all power is off. Stop motors and follow lockout/tagout procedures.
2) Pneumatic power must be disconnected and any pressure accumulation must be released.
3) Never work on a conveyor while it is running, unless maintenance procedure requires operation. When a conveyor must be
operating to perform the maintenance, allow only properly trained maintenance personnel to work on the conveyor.
4) Remove all remaining product from the conveyor system.
5) Staff affected must be informed that maintenance work is being undertaken.
During Maintenance
1) Do not wear loose clothing while performing maintenance on operating equipment.
2) Be aware of hazardous conditions, such as sharp edges and protruding parts.
3) When using hoists, cables or other mechanical equipment to perform maintenance, use care to not damage conveyor components.
Miss-aligned parts are dangerous as conveyor is started after maintenance is completed.
4) Keep area clean. Clean up lubricants and other materials before starting conveyor.
5) Must equip with Personal Protective Equipment (PPE) such as safety glasses, safety shoes, safety helmet etc when performing
maintenance.
After Maintenance
1) Before starting any conveyor after maintenance is completed, walk around the equipment and make certain all safety devices and
guards are in place, pick up tools, maintenance equipment and clear any foreign objects from equipment.
2) Make certain all personnel are clear of the conveyor and made aware that the conveyor is about to be started.
3) Only authorized personnel should be permitted to start any conveyor following maintenance or emergency shut-off.
Introduction
This manual is designed to provide assistance for your planned maintenance schedule. It may become evident that the suggested
maintenance interval can be extended to accommodate your local environmental conditions.
Maintenance of Flextrac Series conveyor systems shall only be done by competent/proper trained personnel who are familiar with
Flexrac Series products. If there is any doubt, please consult your Flextrac Series supplying agent.
Safety Precautions
System Maintenance
INTRODUCTION TO MAINTENANCE
CARET-LEFT
CARET-LEFT
