YOUR • QCA • SPA • EQUIPMENT
VL260 Series Control
Initial Start Up
When your spa is first actuated, it will go into Priming
mode, indicated by “
Pr
.” The Priming mode will last for
less than 5 minutes (press "Temp" to skip Priming Mode)
and then the spa will begin to heat the spa and maintain
the water temperature in the Standard mode.
Temperature Control
The start-up temperature is set at 100F°/37°C. The last
measured temperature is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is
current only when the pump has been running for at least
2 minutes. To display the set temperature, press the
“Temp” pad once. To change the set temperature, press
the pad a second time before the LCD stops flashing. Each
press of the “Temp” pad will continue to either raise or
lower the set temperature. If the opposite direction is
desired, release the pad and let the display revert to the
current water temperature. Press the pad to display the set
temperature, and again to make the temperature change in
the desired direction.
After three seconds, the LCD will
stop flashing and display the current spa temperature.
Jets
Touch the “Jets” button once to activate the low speed of
the pump and again for the high speed. Press the “Jets”
button again to turn off the pump. If left running, the low
speed of the pump will automatically turn off after 4 hours
and the pump’s high speed will automatically turn off
after 15 minutes. It may also activate for at least 2
minutes every 30 minutes to detect the spa temperature
and then to heat to the set temperature if needed. When
the low speed turns on automatically, it cannot be
deactivated from the panel; however, the high speed may
be started.
VS300 =
Jets / Temp / Light
Light
Press the “Light” button to turn the light on and off. If left on, the
light automatically turns off after 4 hours.
Standard Mode
is programmed to maintain the desired
temperature. Note that the last measured spa temperature
displayed is current only when the pump has been running
for at least 2 minutes
Preset Filter Cycles
Two cycles. First starts six minutes after start up. Second
starts 12 hours later.
Programmable for 1, 2, 3, 4, 5, 6, 7,
or 8 hours. Default is 1 hour.
To program, press
Temp/Down/Up, then press Jets to program. Press
Temp/Down/Up to adjust. Press Jets to exit programming.
Pump low will run for duration.
Freeze Protection
If the temperature sensors detect a drop to below
44°F/6.7°C within the heater, IC will be displayed and the
pump will automatically activate to provide freeze
protection. The equipment stays on until 4 minutes after
the sensors detect that the spa temperature has risen to
45°F/7.2°C or higher.
WARNING
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance
with the manufacturer's instruction, may cause interference to radio and television reception. It has been type tested and
found to comply with the limits for a class B computing device in accordance with the specification in subpart J of part 15
of the FCC rules, which are designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
interference, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the
interference by one or more of the following measurers: Reorient the receiving antenna. Relocate the receiver with respect
to the spa. Move the receiver away from the spa. Plug the receiver into a different outlet so that the receiver and spa are on
different circuits. If necessary, the user may find the following booklet prepared by the Federal Communications
Commission helpful: "How to identify and resolve radio-TV interference problems." This booklet is available from the U.S.
Government Printing Office, Washington, DC 20402, Stock No. 004-00000345-4.
5
