background image

low-speed pump is automatically activated. This is 
a normal spa function; no corrective action is 
necessary. Freeze protection is enabled regardless 
of the spa's status. 
 

Winterizing 

 14

In very cold weather you may not want to venture 
outside to use your spa. In this case, you may 
move it to a heated area, or leave it as is until the 
weather warms. If you do leave the spa unused for 
a long period of time in severely cold weather, you 
should winterize the spa to avoid accidental 
freezing due to a power or equipment failure.

.  

Follow these easy steps:  Turn power to the spa 
OFF.  Drain the spa.  Use a wet vac to suck or 
blow out the air injectors, water jets and water 
suction fittings.  Add 1-3 gallons of RV antifreeze, 
depending on the size of the spa, to all the air 
injectors, water jets, suction drains, and filter.  

Caution:  Any lines not receiving adequate 
antifreeze are subject to freeze damage!

 

 

Spa and Cabinet Maintenance 

Acrylic Finish - The acrylic finish on all QCA spas 

is impervious to most of the problems 
associated with non-acrylic finished spas and 
requires very little effort to keep it looking 
bright and clean. Every four months the spa 
should be drained, cleaned, polished and 
refilled. For the cleaning, use any non-abrasive 
cleaner. There are several non-abrasive 

products on the market that can be used for 
polishing. Made specifically for acrylic spas 
are cleaner/polish/sealer combinations, which 
contain reactive silicones instead of wax. If 
these are not available, any high quality 
silicone automotive polish will suffice. 

 

Weather Guard® Cabinet Care

 – Handcrafted 

maintenance free  cabinet surfaces may need to be 
wiped down from time to time with a soap and 
water solution or simply sprayed with a garden 
hose.  Use of harsh chemicals to clean the surface 
will cause the cabinet to discolor. 

 

Redwood Spa Cabinet Care 

Your spa cabinet is 

handcrafted of clear redwood. Unfortunately all woods 
exposed to weather and moisture may warp to some 
degree. However if you wish to retain your cabinet's 
original deep rich look and protect it from warpage, we 
recommended applying a good quality wood protector 
and moisture sealant. The spa's environment such as 
the amount of light, or humidity, will determine how 
often repeat applications are required. Consult your 
local hardware store for wood finishing products and 
their proper application. 

 

 
 

PLEASE NOTE:

 We cannot be responsible for any 

moisture damage to your redwood cabinet

.  For 

your protection, cabinets must be moisture 
sealed. 

 
 
 
 
 

 

 

WARRANTY REGISTRATION

 

This warranty applies to spas manufactured by QCA MAJESTIC™ Spas and sold to an original consumer
purchaser at retail ("Purchaser") after May 1, 1998. To validate this warranty, the Purchaser

 

must complete 

the enclosed warranty registration card and mail it to QCA

 

MAJESTIC™ within 30 days of deliver of the 

spa.   RETURN OF

 

THE OWNER REGISTRATION CARD IS A CONDITION OF WARRANTY

 

COVERAGE.  This warranty is exclusive and supersedes all other representations or obligations of QCA Spas, 
Inc. MAJESTIC™, whether

 

express or implied and whether oral, written

 

or printed.  

 

Your Serial Number is located inside shell on the step or under shell hanging from plumbing within the equipment 
compartment of your QCA Spa. 
 
Date Purchased: 
 
Date Installed: 
 
Dealer: 
 
Address: 

 

Telephone: 

 

Spa Model : 
 
Serial Number: 
 

Warning:

 Elderly persons, infants and anyone subject to heart disease, diabetes, high or low blood pressure, strokes, 

epilepsy or similar afflictions should not enter a spa alone and without consulting a physician. Unsupervised use by 
children should be prohibited. Never use a spa while under the influence of alcohol, anti-coagulants, antihistamines, 
vasoconstrictors, vasodilators, stimulants, hypnotics, narcotics, or tranquilizers. If you are taking medications of any 
kind, or being treated for any illness, consult your physician prior to the use of the spa. A spa should be kept at 
temperatures less then 104° F or 40° C for personal safety and health. 

 
 

To validate your warranty the enclosed warranty must be filled out and returned to QCA Spas, 
Inc. within 30 days from date of purchase. 

 
 

For your warranty see enclosed packet located inside your spa shell. 

 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

Summary of Contents for Paradise Series
















Reviews: