17
3.6 Aux-Trigger Out Contact Type - Normal Close
Instructions:
1. Run Qcam Widget->Choose Option-> (Settings Mode) Custom Mode->Save Option, then choose Settings->
Aux-Trigger Out Contact Type-> Normal Open and press Sync Settings to DVR.
2. Disconnect the USB cable from the QSD-722.
3. Put the QSD-722 mode switch in the custom mode position
3. Connect the QSD-722 to the external device (We suggest using AWG26 wire). The connection screws are
on the top of the QSD-722.
4. Turn on the QSD-722 after connecting the wire correctly.
QSD-722 Trigger out + (Pin5) should connect to external device Trigger in +.
QSD-722 Trigger out - (Pin6) should connect to external device Trigger in -.
Note:
1. Please make sure the voltage input to the QSD-722 trigger out + (Pin5) is under 24V and the current is less
than 1A.
2. Please make sure the current direction is correct. Otherwise, the QSD-722 may be damaged.
Function of this configuration:
Example of GSM alarm or buzzer application/configuration:
