I
NSTALLING
H
ARDWARE
I
NSTALLING
THE
RRU
ON
A
P
OLE
2-8
Figure 2-8.
Fastening the Clamps (A) on the Pole
5. Position the assembly to its final location. Check to be sure that the clamps are
correctly seated on the pole.
6. Once the clamps are evenly aligned on the pole, use a spanner to tighten all the
nuts as directed in the following figure to secure the clamps on the pole to a torque
of 30 kgf-cm (26 lbf-in.). Ensure that the clamps are tight enough to prevent any
movement.
Figure 2-9.
Securing the Clamps (A) on the Pole
7. Insert the M8 B guide screws in the mounting holes on the clamp.
1
2
3
4