I
NSTALLING
H
ARDWARE
D
ISCONNECTING
A
F
IBER
-
OPTIC
C
ABLE
2-12
Figure 2-14.
Connecting the Fiber Cable to the SFP Transceiver
Disconnecting a Fiber-optic Cable
The device supports fiber-optic network connections.
Requirements:
SFP module adapter
Small form-factor pluggable (SFP) transceiver module
SC or Duplex LC fiber-optic cables
Crimp extraction tool
Waterproof kit
The fiber-optic networking cable can be connected to the SFP port. The SFP transceiver
module connects the cable to the SFP port.
To disconnect the fiber-optic cable, follow this procedure:
1. Ensure all power sources are disconnected from the device.
2. Locate the SFP port on the device and turn the protective cap on the gland body to
release it from the gland body.
3. Slide out the gland seal and gland rubber from the gland body.
4. Grasp the locking mechanism and lift it up to unlock the gland body from the
device.
5. Slide out the gland body from the SFP port.
CAUTION!
Ensure all power is disconnected from the system before proceeding.
!