QuantaMesh T1000 Series
17
Network Switch Installation Guide
BASE-T Port Connection
The switch has 48 triple speed (10/100/1000) BASE-T ports.
The BASE-T ports are numbered and have corresponding BASE-T port LEDs.
To connect to the BASE-T port, do the following:
1
Connect one end of an Ethernet cable to the BASE-T port.
2
Connect the other end of the Ethernet cable to a network.
For more information about the BASE-T port LED behavior when the network link is
established, refer to
.
SFP28 Port Connection
The switch is equipped with 4 SFP28 ports designed for 25Gbps data rate. The SFP28
ports support 25 Gigabit Ethernet following IEEE 802.3ae Ethernet for fiber mediums.
The SFP28 ports are numbered and have corresponding SFP28 port LEDs.
To install an SFP28 module, do the following:
1
Slide the SFP28 module into an SFP28 port.
NOTE:
Ensure the SFP/SFP28 module is positioned correctly before installing it into the port.
2
Push completely until the module locks into place.
3
Repeat the above procedures to install additional SFP28 modules.
For more information about the SFP28 port LED behavior when the network link is
established, refer to
.
Summary of Contents for QuantaMesh T1048-LB9M
Page 1: ...QuantaMesh T1048 LB9M Network Switch Installation Guide...
Page 2: ......
