Network Switch lnstallation Guide
25
QuantaMesh T3000 Series
Base-T Port Connection
The switch is a new generation 10GBASE-T solution for data center networking which provides 48
triple speed (100/1000/10 GBase-T) ports.
The Base-T ports are numbered and have corresponding Base-T port LEDs.
To connect to the Base-T port, do the following:
1
Connect one end of an Ethernet cable to the Base-T port.
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
2
Connect the other end of the Ethernet cable to a network.
The Base-T port LED (Link/Activity LED) lights green when the network link is established.
QSFP+ Port Connection (MPO Type Connector)
The switch is equipped with 6 QSFP+ (Quad SFP) ports. There are two types of QSFP+ ports:
• There are four 40G QSFP+ ports on the front panel which support 40G/per port or fan out
to 4x10G by using the fan out DAC cable described in the
“40-Gigabit ports”
section on
page
24
.
• The QSFP+ port on the rear panel provides only one channel of data in one pluggable
interface.
The QSFP+ ports are numbered and have corresponding QSFP+ port LEDs.
To install a QSFP+ module, do the following:
1
Slide the QSFP+ module into a QSFP+ port.
2
Push completely until the module locks into place.
2
43
44
45
46
47
48
PSU1
PSU2
FAN
49
57
50
51
52
58
53 54
59 60
55 56
65 66
61 62
67 68
63 64
AC
DC
70
69
Front panel
Rear panel
3
Repeat the above procedures to install additional QSFP+ modules.
The QSFP+ port LED lights green when the network link is established.
