Installation Instructions
10
Manual for N2 series
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX12V power, and
a LAN adapter which supports this function is used. Then connect this header to the
relevant connector on the LAN adapter, set Wake up on Ring/LAN as Enabled in the
POWER MANAGEMENT SETUP section of the BIOS. Save and exit, then boot the operat-
ing system once to make sure this function takes effect.
Wake-Up On Internal Modem (WOM)
Through this function, the system which is in the suspend or soft-off status can be
waked up by a ring signal received from the internal modem. When this function is used,
be sure an internal modem card which supports this function is used. Then connect this
header to the relevant connector on the modem card, set Wake up on Ring/LAN as
Enabled in the Power Management Setup section of the BIOS. Save and exit, then boot
the operating system once to make sure this function takes effect.
WOL
1
+5VSB
GND
Signal for waking up
+5V standby
GND
1
WOM
Signal for waking up
N2en.p65
02-6-4, 16:53
10
Summary of Contents for N2
Page 10: ...This page is intentionally left blank 4 N2en p65 02 6 4 16 52 4...
Page 44: ...38 Manual for N2 series N2en p65 02 6 4 16 53 38...
Page 45: ...Appendix 39 Manual for N2 series N2en p65 02 6 4 16 53 39...
Page 64: ...58 Manual for N2 series DDR DIMM Configuration Matrix for IGP 128 N2en p65 02 6 4 16 54 58...