44
Manual for N2 series
3. Hot key for Recovery
There are 12 options, including NULL and F2~F12. Key F12 is default. If NULL is selected,
Restore interface can not be used with pressing hotkey. If you select one key of the rest
11 options, you can enter Recover interface by pressing the hotkey you setup during
POST.
NOTE :
If the Backup hotkey and Recover hotkey have been set with the same key, the default
will be Backup hotkey.
Backup Function Introduction
press Backup Hotkey to enter Backup Interface during the POST(Power On Self Test), then
the follwing interface will appear. You can scroll the highlight bar to the option you want to
work with using arrow key. Press ENTER to confirm.
figure-3 Backup Interface
Hard Disk Selection Menu
If you installed the system with several
IDE hard disks, and you have pressed the
backup or restore hotkey during POST,
hard disk selection menu will popup be-
fore you enter backup or recovery
interface, in which all of the IDE hard disks
installed on your system will be listed. You
can scroll the highlight bar to the hard disk
you want to work with using arrow key.
Press ENTER to confirm, and the following
operation will be performed on the selected
hard disk:
figure-2 Hard Disk Select
1
Backup Partition Table
2 Backup System Partition C:
3 Backup Whole Disk
4 Backup CMOS Setup
5 Free Backup Area
6 Exit Backup Menu
N2en.p65
02-6-4, 16:53
44
Summary of Contents for N2
Page 10: ...This page is intentionally left blank 4 N2en p65 02 6 4 16 52 4...
Page 44: ...38 Manual for N2 series N2en p65 02 6 4 16 53 38...
Page 45: ...Appendix 39 Manual for N2 series N2en p65 02 6 4 16 53 39...
Page 64: ...58 Manual for N2 series DDR DIMM Configuration Matrix for IGP 128 N2en p65 02 6 4 16 54 58...
