Manual for P2S series
l
Suspend Type
Stop Grant
Select the Suspend type.
PwrOn Suspend
l
MODEM Use 3,4,5,7,9, Special Wake-up event for Modem.
IRQ 10,11
NA This function is not applied.
l
Suspend Mode
Disabled
The system never enter Suspend mode by timer.
1Min ~ 1Hour
Define the continuous idle time before the system
enters Suspend mode. If any items defined in
“PM Events” are on and activated, the system will
be woken up.
l
HDD Power
Disabled
HDD’s motor will not be off by timer.
Down
1 - 15 Min
Define the continuous HDD idle time before the
HDD enters power saving mode (motor off).
l
Soft-Off by
Instant-Off
The system will immediately power off once the
PWR-BTTN
power button is pressed.
Delay 4 sec
The system will power off when power button is
pressed for 4 seconds.
l
CPU THRM-
12.5%, 25%,
Select the duty cycle of the STPCLK# signal,
Throttling
50%, 37.5%,
slowing down the CPU speed when the system
62.5%, 75%,
enters green mode.
87.5%
l
Wake-Up by PCI
Enabled
Allow the system to be waked up by PCI card.
card
Disabled
Do not allow the system to be powered on by
PCI card.
l
Wake-Up by
Enabled
Allow the system to be powered on when a
Ring/LAN
Ring indicator signal comes up to UART1 or
UART2 from external modem (to LAN Wake-up
Header from LAN adapter or to modem Ring on
Header from internal modem card).
Disabled
Do not allow Ring/LAN wake up.
l
Resume
Enabled
RTC alarm can be used to generate a wake-up
by Alarm
event to power up the system.
30Disabled
RTC has no alarm function.
l
Primary IDE 0/1,
Enabled
Reload global timer, when there’s an IDE event.
Secondary IDE 0/1 Disabled
Do not reload global timer.
BIOS Description
δÃüÃû-2
02-2-19, 11:00
38