Manual for P2S series
Note:
a. During the process of partition backup or recovery, a guage will be shown as below,
the backup or recovery speed is about 4-5Mbyte/s. See figure-4.
b. If a disk I/O error occurs during the process of partition backup or recovery, this
means there’s physical damage on the hard disk, however users can ignore it and
continue the process.
2.3
ATTRIB PAR
Function : Allows users to modify the properties of the partition (eg. FAT16 ->
FAT32) after entering OS.
Limitation : None.
Steps
: After pressing this button, turn on/off the switch.
Note:
a. The switch resets to the default setting “disable” every time the system reboots.
b. In order to implement this function, users need to enable the switch when
install-
ing the OS or modifying the partition properties. Please note: Do not create or delete
partitions or change the partition size when modifying the partition properties.
2.4
BACKUP CMS
Function : Backups all CMOS settings.
Limitation : None.
Steps
: After choosing this function, the current CMOS settings will be saved.
2.5
RE-CVR CMS
Function : Recovers all CMOS settings.
Limitation : None.
Steps
: After choosing this function, the latest backup of the CMOS settings
will be recovered. The system needs reboot in order to validate the
new CMOS settings.
Note
: If users have never backuped the CMOS settings, a wrong message
will be shown after choosing this function.
figure-4 Backup
Partition
Appendix
δÃüÃû-2
02-2-19, 11:00
57
