6
7
Align the hinge of the Tightening
Strap with the corner of the post by
sliding it through the Long Mounting
Brackets.
Insert Edge Protectors as needed to
protect exposed post corners from
the strap rubbing on them.
Hand tighten the Tightening Nut
as much as possible, then use the
Tightening Tool to tighten the strap
around the post.
Tighten the strap firmly and make
sure the Stair Mounting Kit is secure.
Step 8
Once the installation is secure and
the strap is very tight, cut the excess
strap as close as possible to the
Tightening Nut using a sturdy pair of
scissors.
After cutting, use the Tightening
Tool to loosen the Tightening Nut
approximately 1-2 turns until the cut
end of the strap is protected inside
the Tightening Nut.
Recheck the security of the Stair
Mounting Kit.
Repeat for Bottom Mouting Bracket.
Step 9
Install gate on the Stair Mounting Kit, following the gate
instructions.
If your square post/banister is less than 2.4
″
(67 mm)
wide, use the two short Mounting Brackets.
