SYSTEM OVERVIEW
Your Systemline installation will include some, if not all, of the following items:
To program alarm or change time*
(assuming DMS is in Stand-by mode)
If a zone splitter is installed within a zone to allow you to switch between a 2nd set of speakers
in a different room there will be an illuminated LED below the one or both of the two buttons
marked "A" and "B".
The illuminated LED indicates that the speakers are active. It is possible to have pair "A" active
or pair "B" active or both. Note it is not possible to turn both pairs OFF so if you wish to switch
from pair "A" to pair "B" you must first activate pair "B" before being able to deactivate pair "A".
Systemline
USER GUIDE
Systemline Controller S4.3
Nerve centre of the system. The
Controller should be left switched
on permanently, and once set up
by your installer it should need
no further adjustment.
Display Module (DMS)
Displays information about the
status of Systemline and also
receives commands from RHS
Remote Handset (RHS)
Issues commands to select
and control sources from the
comfort of your armchair.
Keypad Module (KMS)
Used to select source and issue
commands to that source.
USER GUIDE
1
USER GUIDE
4
Prime Zone (A)
Selected
(B) Sub Zone
Selected
*Clocks on dms displays will synchronise with the clock on
zone a
dms at 12:00
Press
Alarm button
Press
Alarm button
Press
Alarm button
Press
Alarm button
Press
Alarm button
Alarm ON
Advances
hours
Use Tuner
Advances
hours
Alarm OFF
Advances
minutes
Use CD
Advances
minutes
Enters alarm On/Off mode
Enters alarm setting mode
Enters source selection mode
Enters clock setting mode
Exits set up mode
DISPLAY
BUTTON A
BUTTON B
