QED uPlay Stream, Manual

14

5 

The uPlay Stream settings page

5.1  The Setup section

5.1.1  Device settings

WiFi Interface (WiFi OFF):

 Check / uncheck the box to disable 

/ enable the WiFi function of the uPlay Stream. Press the 

Apply

button to apply changes. When applying changes to this setting, 

the uPlay Stream will reboot automatically.

Device Name:

 The default device name ‘QED uPlay Stream’ can 

be changed to identify different units when there is more than 

one uPlay Stream in the network. For example, you can rename 

them to ‘Living Room’, ‘Bedroom’ etc.
To rename, just enter a new name in the New Name field and 

press the 

Apply

 button.

5.1.2  WiFi selection

Press the 

Go To Network Selection

 button to connect to WiFi 

networks. Please refer to section 4.3 for connecting to WiFi 

networks.

5.1.3  Device information

This section shows information about the unit, including the 

LAN

and 

WiFi IP Address

, the unique 

LAN

 and 

WiFi MAC Address

 of 

the unit, the 

Firmware Version

 and the unique 

Serial Number

 of 

the unit. The LAN or WiFi address field will be blank if the unit is 

not connected to a LAN or WiFi network.

5.2  The WiFi Profiles section

The uPlay Stream will store the WiFi network it is connected to 

as a WiFi Network Profile. You can Add, Edit, Delete and Activate 

the WiFi network profiles in this section. To add, edit, delete or 

activate a profile, just select the profile from the list and press 

the corresponding button. There will be an icon  

next to 

the currently activated profile.

5.3  The Advanced section

5.3.1  Link Status

The Link Status section shows the current WiFi and LAN 

connection status of the uPlay Stream.
In the WiFi Link Status section, the LINK SSID shows the name 

(SSID) of the WiFi network you are currently connected to. The 

Link Speed (in Mbps) and Throughput (in kBps) are also shown 

and updated regularly in this page. 
The Signal Strength1 status is useful for locating the uPlay 

Stream in your setup environment. If the signal strength is too 

weak, the playback may get interrupted occasionally.  The Signal 

Strength2 and Signal Strength3 statuses are reserved, and they 

will only show Weak 0%.
Other WiFi connection information including IP Address, Subnet 

Mask, Default Gateway, Primary DNS Server and Secondary DNS 

Server can also be found in this section.