1.5
Batteries
Batteries specifications
The SLATE106 device is designed to work with 4 CR2430 Lithium coin batteries. The battery model has been chosen to obtain the best performances for SLATE106 using.
The batteries features are described below. Use the same reference to obtain the best battery lifetime. However, an equivalent reference may be used.
Type
CR2430
Nominal voltage
3V
Typical capacity
290mAh
Chemical system
Lithium Manganese Dioxide
Reference
2430/CR2430 VP-1 ENERGIZER LITHIUM [Energizer]
Replacement procedure
⚠
In case of batteries replacement, change the 4 batteries at the same time with the new ones. The batteries must be changed by a qualified people, who is
knowing perfectly the replacement procedure. The batteries must be recycled according to your country’s regulations.
Remove each battery with its holder, using a little slotted screwdriver. Grab and then pull the edge of the plastic holder, remove the old battery from the holder
Insert the new battery
with the positive side facing up
. Glide the battery with holder into its place using your finger or screwdriver pushing into the plastic of holder
part: you must feel a clip when the battery is installed
Repeat the same operation for the 4 batteries.
Battery energy status (%)
The battery energy status in percent (%) is reported
through the
SMH300
hub Web configuration interface. For further information, refer to the
SMH300 User manual
.
through the
Slate Maintainer
mobile application. Refer to the
Slate Maintainer application (RFU)
Grab the edge of holder
Pull the holder
to the right
Insert new battery
Glide battery and holder
13
