14
◬
When installed on the
NAPOE109kt
or
NAPOE109ft
products having a mounting bracket with a
POGO
connector, before mounting the screws
to lock the device, check that the TAB10s device is installed on the
NAPOE109kt
or
NAPOE109ft
products stricly on the vertical position else
some unexpected power supply issue could be faced.
To check that the tablet is properly supplied, ensure that the tablet is displaying the
AQS
desktop content, or any App on the screen.
Swipe from the extreme top of the screen to the bottom of the screen to check the pictogram inside the notification banner.
WLAN_1
network
connectivity
Information
When this WIFI pictogram is displayed and filled with the number of bars corresponding to the WIFI reception level,
the
WLAN_1
connection is up.
If the WIFI pictogram is displayed but stays empty, the
WLAN_1
connection is down.
LAN_1
network connectivity
Information
When this LAN pictogram is displayed, the
LAN_1
connection is up.
When this LAN pictogram is not displayed, the
LAN_1
connection is down.
Only one of the interface can be up at a time.
When the TAB10s device is properly installed with
AQS
running with a consistent network pictogram, you can remove the protective film from the
screen.
Summary of Contents for TAB10s
