20
Dipswitches for microphone and camera
For confidentiality purpose, the TAB10s device has two switches at the back of the product allowing to activate or deactivate respectively the
microphone and the camera peripherals.
When the DIP switch is facing the crossed microphone, the microphone peripheral is deactivated.
When the DIP switch is facing the crossed camera, the camera peripheral is deactivated.
Example of configuration when the microphone
and the camera
peripherals are deactivated:
Example of configuration when the microphone
and the camera
peripherals are activated:
Micro-SD card
The micro SD card connector is located on the rear face of the TAB10s. A
micro SD
serigraphy is showing the connector location.
Step 1: Place the micro SD card in the right sense close to the connector entry.
☛
It may be required to lift the micro SD card so that it can enter into the connector. Press a little on it to tilt it.
1
2
3
4
Summary of Contents for TAB10s
