24
1.9 Test card
When the
Test card
is activated, the device displays one test pattern content by network interface supported by the device. It displays important
information to assist in the device configuration.
On a TAB10s device, the test pattern content is displayed thanks to a
Test Card
App that is launched at device start-up when the
Test card
is
activated in the device configuration Web user interface.
◬
When the
Test Card
App must be executed, no other App can be executed. To execute successfully another App, your must deactivated the
Test Card
App in the device configuration Web user interface.
If you are using a
NAPOE109ku
adapter, a
NAPOE109kt
adapter, a
NAPOE109ft
adapter or a
PoE to USB-C
adapter, the
Test card
displays in alternance:
the test pattern content for the
LAN1
network interface for ten seconds,
the test pattern content for the
WLAN1
network interface for ten seconds.
If not, the
Test card
displays only the test pattern content for the
WLAN1
network interface.
☛
For TAB10s devices, the
MAC Id
value is the MAC address value of the WLAN interface. It is identified in the test pattern content by the
key
pictogram
☛
The
up
STATE
*on the
WLAN1
network interface means that the device is connected to a WIFI router. The
down
STATE means that the
device is not connected to a WIFI router.
☛
When using a
NAPOE109kt
adapter, a
NAPOE109ft
adapter, a
NAPOE109ft
adapter or a
PoE to USB-C
adapter, the
up
STATE
on the
LAN1
network interface means that the adapter is able to provide the network connectivity. The
down
STATE means that the adapter is not able to
provide the network connectivity due to either a wrong installation of the TAB10s device on the wall-mount or due to a wire crimping trouble on
the krone connector
.
☛
Only one network interface can be activated at a time. The
I/F on
status means that the current interface displayed is kept activated by
the OS; the
I/F off
status means that the current network interface (or I/F) displayed has been deactivated by the OS.
☛
The white circles
are filled with a white dot from the left to the right, each time a test pattern content for a new network interface is
displayed. When there is one LAN1 interface and one WLAN1 interface supported by the device, two white circles are displayed: the left one for the
LAN1 interface, the right one for the WLAN1 interface.
☛
In
native
mode, when navigating in the Android settings menu, if the
Test card
App was running, the
Test card
App is stopped. To relaunch
it, you can either restart the device or launch the
Test card
App available in the Android Apps view.
1
2
3
4
Summary of Contents for TAB10s
