19
1.7 Connectors pin-out
☛
The access to some connectors or DIP switches may require to remove the mounting bracket or remove the TAB10s device from the wall. Refer
to the chater §
Procedure to access to the back connectors
USB-C connector
The device can be supplied by the USB-C connector located at the bottom face of the product.
Information type
Value
Type
USB type-C
Data
USB 2.0
Power
USB PD¹ (Power delivery)
This is the USB-C pin-out for the TAB10s:
☛
The USB-C connector is supporting Ethernet over USB.
¹
The TAB10s device is an USB sink device by default, in order to be supplied by an external power source device. It implements data-role swap, in order
to be able to become the data host, and hence, to support ethernet-to-usb external bridges while being supplied by this bridge. When operating in sink
mode, you must take care when selecting your power supply source and usb cable, select a power source able to drive 5 V - 3 A, and choose high quality
cables, especially when you have a long distance between source and the TAB10s device.
Qeedji
advises to use
EXC.NAPOE109KU
accessory, as it is fully
qualified with the TAB10s device. The TAB10s device can be an USB source device only when supplied by the POGO type connector. So it can support an
external USB dongle for example. In this case, you have to take care to not sink too much current through USB-C connector.
POGO type connector
The device can be supplied by the POGO type connector located at the back of the product.
VCC,
GND,
USB+,
USB-,
GND,
VCC.
☛
The POGO type connector allows to supply the device and offers an USB 2.0 host interface, for Ethernet over USB for example.
1
2
3
4
5
6
Summary of Contents for TAB10s
