78
4.1.11 Maintenance > Test card
In the
Maintenance
tab, select the
Test card
menu to enable or disable the test pattern. The test pattern is often enabled during:
installing devices on the network,
the configuration of the output resolution and overscan.
To activate the
Test Card
App launching at device start-up, set the
Test card
toggle button to
activated
. To not activate the
Test Card
App
launching at device start-up, set the
Test card
toggle button to
deactivated
.
☛
The test pattern content is not displayed by the TAB10s device at start-up when it is coming straight from factory. For further information
about the test pattern content, refer to the chapter §
.
☛
When the
Test card
App is launched at start-up, the other App cannot be executed.
☛
The displaying of the IP V6 address value starting with the prefix
fe80::
is not supported in the Test Card content. For further information,
contact your IT department so that your network is advertising the IP V6 address with another prefix (ex:
fc00::
).
Summary of Contents for TAB10s
