UG-1084
ePAQ-9405
User’s Guide
Copyright © 2017 QEI
Test Panel
29
The output shown on the Test Panel display is continuously updated.
15.7 DATE and TIME Commands
The “Date” and “Time” commands are used to set the internal clock of the ePAQ to
the correct time and date as required.
To enter or view the current date, type
DATE
<enter>. The following will
be displayed:
Current Date Is 09/21/1992
Enter New Date:
1. To enter New Date: type the new date in the format shown at the
cursor. To accept the current date, type <enter>.
2. Then the time and the new date, if entered, will be displayed.
Current Time Is 15:52:16
Current Date is Thu 09/21/2000
3. To enter or view the current time, type
TIME
<enter>. The following
will be displayed:
Current Time Is 15:52:20
Enter New Time: -
4. To enter New Time, type the new time in the format shown at the
cursor. To accept the current time, type <enter>.
5. Then the new time, if entered, and the date will be displayed:
Current Time Is 15:53:20
Current Date Is Thu 09/21/2000
15.8 Reading Analog Values (RA)
Up to eight (8) analog points can be selected and displayed at a time. To enter the
desired analog points, proceed as follows:
Type in
RA
(space) and the number or numbers of analog points, not necessarily in
any order. Each number must be followed by a space. Points begin with point
number 0 (zero). The values are displayed as decimal integers. The displayed
values are continuously updated.
Summary of Contents for ePAQ-9405
Page 1: ...UG 1084 ePAQ 9405 User s Guide December 2018...
Page 4: ......
