-2-
ASSEMBLY
Open the base and use provided Allen wrench,
screws, bolt and nuts to assemble:
1. Two cross bars;
2. The blade onto the base
3. The handle
BRACE SETTINGS
On the cutter base, there are a few sets of
slots used for the brace attachment. Always
use the slots closer to the pivot of the blade
according to the width of the plank. The
closer to the pivot of the blade, the more
cutting power you will get.
90 DEGREE CUT
Place the flooring plank onto the cutter base
and position the brace in the appropriate
slot at the required length. Then push down
the blade by using the handle. The cutter
is designed to cut through flooring by
removing a small amount of flooring.
Please note that a slightly rough edge is
normal. The cut edge will meet the wall
and be covered by a base board or quarter-
round molding.
WARNING:
Avoid contact
with the steel teeth along
the cutting slot, which may
cause injury.
Summary of Contents for 10-37
Page 11: ... 11 NOTES NOTES NOTAS ...
