17
THe LASer GUIDe (FIG. Y)
For your own safety, never connect the plug to a
power source outlet until all the adjustment
steps are complete and you have read and
understood the safety and operational instructions.
To turn laser guide on
•
to turn laser on, press on/off rocker switch (1) to "i"
position.
•
to turn laser off, press on/off rocker switch (1) to "o"
position.
NOTE:
your tool is equipped with the Laser Guide using
a class iiia laser beam. the laser beam will enable you
to preview the saw blade path on the stock to be cut
before starting the tile saw. this laser guide is powered
by two aaa 1.5 volt batteries.
ALIGNING THe LASer GUIDe (FIG. Z)
if you choose to use the laser guide, the laser beam
must be correctly aligned with the blade to ensure
straight, even cutting. your tool is equipped with the
Laser Guide cutting guide using class iiia laser beam.
the laser beam will enable to preview the saw blade
path on the stock to be cut before starting the tile
saw. this laser guide is powered by two aaa 1.5 volt
batteries. the laser on/off switch must be turned on for
the laser line to show.
WARNING
!
Fig. Y
1
AVOID DIreCT eYe CONTACT
•
Laser radiated when laser guide is turned on.
Avoid direct eye contact. Always un-plug the
tile saw from power source before making any
adjustments.
•
Laser Warning Label: Max. Output < 5 mW
Wavelength: 630-660nm, Complies with 21
CFr 1040.10 and 1040.11 Class IIIa Laser product.
•
Laser Aperture Label: AVOID eXpOSUre: Laser
radiation is emitted from this aperture.
•
NOTe: All the adjustments for the operation of
this machine have been completed at the factory.
Due to normal wear and use, some occasional
readjustments may be necessary.
•
CAUTION: Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure.
•
CAUTION: The use of optical instruments with
this product will increase eye hazard.
•
Do not attempt to repair or disassemble the
laser. If unqualified persons attempt to repair
this laser product, serious injury may result. Any
repair required on this laser product should be
performed by authorized service center personnel.
Fig. Z
top view
cutting line
blade
laser beam
laser beam
WARNING
!
tile
cutting line
Summary of Contents for 900 XT PRO
Page 9: ...9 UNPACKING YOUR JOBSITE TILE SAW B C A D E F G H I J K L M N O P...
Page 25: ...25 PARTS LIST 900 XT PRO TILE SAW 61900Q...
Page 30: ...30 NOTES...
Page 31: ...31 NOTES...
