- 9 -
DON’Ts
1. Do not operate the saw without all safety guards in position.
2. Do not operate the saw with blades larger or smaller than recommended.
3. Do not cut dry with blades marked “Use Wet.”
4. Do not exceed maximum RPMs recommended by the blade manufacturer.
5. Do not force the material into the blade. Let the blade cut at its own speed.
6. Do not cut material not recommended by the blade manufacturer.
SAW MAINTENANCE
Do not service, clean or maintain the saw without first turning off the motor and unplugging the saw from it's power
source. Failure to do so may result in serious injury to the operator.
1. “Truing” the cutting table may be required occasionally. The saw blade must be 90˚ to the “tile stop” on the
cutting table to prevent blade “binding” while cutting tile.
a. Use a carpenter’s square, held against the blade and against the “tile stop”, at the back of the
cutting table.
b. If the two are not square (90˚), loosen the wing nut on the left guide rail, and move the guide rail until the
blade and cutting table are exactly square.
c.
Tighten the wing nut on the guide rail securely.
2. For longest life and best performance, clean the saw after every use.
3. Wipe off all exterior surfaces and keep the cutting table clean and free of tile chips and debris.
4. Wipe off both the guide bars and the rollers on the cutting table.
5. Place light machine oil on the guide bar to facilitate smooth travel of the linear guide assembly.
TROUBLESHOOTING
OVERHEATING OF SAW:
A. Turn saw off and let it rest until motor is cool to the touch.
B. Check and clean the ventilation slots, removing blockage and dirt.
THE SAW DOES NOT START:
A. Check that power cord is properly plugged in.
B. No power from outlet.
C. Switch is damaged.
ACCESSORIES INCLUDED WITH SAW
•
Spanner A
•
Spanner B
•
7 in. (180 mm) Continuous Rim Diamond Blade
•
Angle Gauge
•
Parallel Guide
STATE-OF-THE-ART FEATURES OF THIS SAW
•
Lightweight and portable
•
Adjustable cutting table allows for precision 45 degree cuts
•
Direct drive, 3/5 HP motor, 3,600 RPM
•
Automatic thermal overload protection protects saw from power surges and motor overheating
•
Lightweight for easy setup and maintenance
WARNING
