Page 7 of 8
Inhalation of dust is hazardous to health! When carrying out
the work which can produce dust, please always wear a dust
mask.
●
Loose the fastening nut.
●
Connect the hose to the exit of the handle (Fig.9)
●
The other end of the hose is connected to the vacuum
cleaner;
7.
Operate the Machine
-Do not control the machine’s head.
-Hold the machine with both hands.
-Before operating the machine, make sure every fastening handle is closed.
-Connect the machine to the main power supply.
- Before switching on the machine, keep the sanding head slightly away from the work surface.
- Start the machine for necessary sanding work.
Operate the machine with short length in narrow and awkward area.
Run the machine with medium length for higher walls.
Use the machine with longest length for ceilings.
- Do not over-press machine so that to avoid overloading! Press with proper pressure for better grinding
effects. Good grinding effects and quality are mainly decided by choosing the right abrasive material.
-Once finishing the sanding task, switch off the machine.
8. CARE AND MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. Always store your power tool in a dry
place.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
If a fault can not be rectified, return the mixer to an authorised dealer for repair.
Cleaning
-
Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as possible.
-
Clean the unit by rubbing it with a clean cloth or blow it clean using low-pressure compressed air.
-
We recommend that you always clean the unit immediately after using it.
-
Do not use cleaners or solvents; these will attack the plastic parts in the unit. You must also ensure
that water cannot get into the inside of the unit.
Carbon brushes
-
If excessive sparking occurs you must have the carbon brushes checked by a qualified electrician.
Attention! Only a qualified electrician is allowed to change the brushes.
