16
– 05|2016 – Subject to change.
KidGoo1 – Q8000-S
Assembly
Fitting the wheel guard
The wheel guard on both sides of the cabin prevents the wheels from getting stuck on pillars
or similar obstacles.
f
Prepare the wheel guard by removing the two prefitted screws from the holes.
f
Hold the wheel guard close to the wheel against the cabin frame so that the following
conditions are fulfilled:
–
The holes on the wheel guard face the holes in the cabin frame tube.
–
The curved outside of the wheel guard widens towards the wheel.
f
Open the canopy and insert the 2 screws from the
inside through the tube of the cabin frame.
f
Position the wheel guard on the outside onto the
screws with the holes so that the bent exterior side
of the wheel guard gets broader towards the wheel.
f
Loosely screw the self-locking nuts onto the threads. When doing this, make sure that the
circular side of the nut is not against the thread.
f
Use a size 4 hex key to alternately tighten both screw connections (tightening torque max.
4 Nm).
f
Mount the second wheel guard in the same way for the other wheel.
Mounting the push handle
The push handle has multiple height settings and is used for pushing, pulling and manoeuvring
your
KidGoo1
. And if it becomes necessary, it performs an important safety function as a roll-bar.
The push handle is attached at the top of the cabin frame using 2 quick-release clamps.
f
Position the cabin upright.
f
Unfold the push handle completely. To do this, keep the light grey pushbuttons pressed on
“Adjusting the push handle” on page 26
.
f
Loosen the two pre-assembled quick-release clamps
and remove them.
f
Hook the upper loops of the canopy into the tube
ends at the cabin roof.
f
Insert the two ends of the push handle into the tube
ends at the cabin roof.
Caution!
Avoid twisting the brake cable. It should be possible to lay it towards the wheel axle
after assembly of the push handle.
