KidGoo1 – Q8000-S
Subject to change. – 05|2016 –
17
f
Place the quick-release screws from the outside
through the holes of the following parts to secure the
connection:
–
Reinforcement plate (outside of the push handle)
–
Push handle
–
Tube ends of the cabin roof
f
Place the nut onto the thread and tighten until the quick-release clamp can only be closed
with a bit of force.
f
Close the quick-release clamp.
Danger!
Make sure that the push handle is also mounted for every journey in Trailer mode.
Only then does the cabin have a roll-bar.
Relocating brake cable
You can operate the disc brake system using the lockable
brake lever in the middle of the push handle. The brake
cable is laid along the storage space towards the two disc
brakes at the wheel axle. Two loops which are designed
as Velcro fasteners are used as attachments.
f
Guide the brake cable through the two loops and close
the Velcro fasteners.
Inserting the wheels
f
Place the cabin on one side to allow the wheel to be inserted more easily.
f
Insert one wheel into the wheel axle:
–
Hold the wheel so that you can press your thumb
onto the rubber cap on the outside of the wheel
hub.
–
Press on the rubber cap and keep it pressed in
order to open the push-in axle fastening.
–
Insert the wheel’s push-in axle as far as it will go
into the axle retainer.
–
Release the rubber cap to secure the push-in axle.
f
Pull on the wheel to check that the wheel is locked in
the axle retainer.
f
Turn the cabin onto its other side and insert the
second wheel in the same way.
Assembly
