KidGoo1 – Q8000-S
Subject to change. – 05|2016 –
21
Assembly
–
Align the rear wheel so that it can turn freely.
–
Align the coupler so that it faces horizontally to the rear.
f
Tighten the connection firmly in order to secure the rear wheel:
–
Quick-release axle: Tighten the cap nut until you can close the clamp with a certain amount
of pressure.
–
Full axle: Tighten the nut with a spanner.
Tip!
The coupler can be permanently mounted on the bicycle. Additionally available
couplers enable you to use the
KidGoo1
on different bicycles, see
.
The supplied universal coupler is suitable for mounting on most rear-wheel versions.
It it does not fit your bicycle, you can find suitable special couplers and conversion sets
on the Weber Technik GmbH website:
Installing optional accessories
Accessories are available for
KidGoo1
which extend the range of applications or simplifies the
use in certain situations. You can find information about the assembly and handling of these
accessories here.
Adaptor for baby seat of Class 0+
Using the optionally available adapter (
art. no.
AD-800
)
you can replace the bench seat of the
KidGoo1
with a
baby seat of the Class 0+. This is the safest method to
transport babies up to a weight of 13 kg in the
KidGoo1
.
The adapter is screwed tightly into the cabin frame;
the click system of the adapter is compatible with
models from Maxi Cosi and the Qeridoo baby seat 0+
(
art. no.
1298
).
The adapter set contains a screw set and the following
components:
[A]:
Adapter L (left, with holding rod)
[B]:
Adapter R (right, with holding rod)
[C]:
Safety harness with harness catch and 2 loops to
fasten the ends of the adapter
